What to do if the excavator accumulates dust？

The excavator has now become one of the indispensable equipment in construction machinery. It alleviates tasks that humans cannot do in many fields. In daily construction, it is generally used in 

many aspects such as road construction, digging, and sewer digging. work.

After the excavator is running, the excavator tracks, casing, air filter, bucket and other aspects must be cleaned. This cleaning is an important link to ensure that the future construction can proceed 

smoothly, otherwise the excavator will malfunction.

Step 1 . Diesel softens dirt

Pour the diesel into the spray bottle, spray it on the butter, wait 10 to 30 minutes, and then scrape again. This time you can use a steel wool ball to scrape off the dirt. Generally, the paint will not be scraped off.

Step 2  . Soften heavy oil detergent

After using up the diesel, pour in the heavy oil detergent and spray it. Here are a few things to pay attention to: Heavy oil detergent has a strong ability to remove oil. Before use, spray a little on the 

paint for a so-called skin test. Some machines have poor paint or poor time, which will cause the paint to fall off and turn white after spraying. , Heavy oil detergents are highly corrosive and will 

corrode the skin and nails, causing pain and itching. Be careful to wear rubber gloves and glasses if possible, or buy heavy oil detergents that will not hurt your hands.

Step 3  . Soften and clean again

After spraying the diesel and heavy oil detergent, the butter begins to soften. Repeat the above steps and scrape off the dirt again. It is not ruled out that some cannot be scraped. At this time, you need to use hand washing powder, which is specially used to remove dirt. For oil stains, you can easily remove those oil stains that cannot be scraped with steel wire balls.

Step  4. Wipe away any remaining stains on the surface

The oil stain is almost cleaned. At this time, there is a lot of oil and water on the paint surface. At this time, mix washing powder with water, and then use washing powder water to wipe the paint surface again.

Step 5 . Rinse with high-pressure water gun

Rinse with a high-pressure water gun and it will basically be clean. If you don't have a high-pressure water gun, you can wash it slowly with clean water and it will be very clean. If it's still not clean, 

just repeat the above steps.

The use of excavators has greatly improved the efficiency of industrial construction. As long as the excavators are kept clean and important operating parts are maintained every day, the life of the 

excavators can be increased. Through the above introduction, I believe everyone has an understanding of this issue.

Welcome to leave a message for consultation